• WLAN password up to 64 digits
• WLAN transmission power adjustable
• Improved detection of the DCC track signal

• Offline storage of measured data in internal memory: measured value for speed too high, since V1.04 introduction slow speed corrected
  
  
  New:

• Low-pass filter with hysteresis for recording of speed and distance, reduction of disturbances and sporadic peaks in speed diagram in PIKO Analyst, avoidance of visible speed jumps on display

• Bug-Fix: Data of the position sensor temperature compensated
• DCC protocol is recognized correctly even in multiprotocol environments, adaptation of bit times
• Radio pictogram for network connection at start-up when connecting via router (instead of black screen)
• Minor optimizations

• Bug-Fix: Optimized averaging of speed display
• Extension of the measuring range for very slow speeds (<1mm/s)

Note: When driving very slowly, it may take longer for "0.00km/h" to be displayed after the locomotive / car has stopped, as the measuring interval is longer. However, the distance is measured correctly in any case.

• Distance counter was not saved, if Measure Car was shut down manually 
  

• Languages Polish and Italian added
  
• Reset distance counter via central unit with F3, 3 times quick switching (like adding a new locomotive addess)
• Minor bugfixes

• Calibration for wheel size to measured distance (pre-calibrated)
• Battery symbol charging and discharging behaviour adapted
  

• WiFi module, long term connection problem fixed